/* * top_tb.v * * vim: ts=4 sw=4 * * Copyright (C) 2019 Sylvain Munaut * All rights reserved. * * BSD 3-clause, see LICENSE.bsd * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions are met: * * Redistributions of source code must retain the above copyright * notice, this list of conditions and the following disclaimer. * * Redistributions in binary form must reproduce the above copyright * notice, this list of conditions and the following disclaimer in the * documentation and/or other materials provided with the distribution. * * Neither the name of the nor the * names of its contributors may be used to endorse or promote products * derived from this software without specific prior written permission. * * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" AND * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED * WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE * DISCLAIMED. IN NO EVENT SHALL BE LIABLE FOR ANY * DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES * (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; * LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND * ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS * SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. */ `default_nettype none module top_tb; // Signals // ------- wire spi_mosi; wire spi_miso; wire spi_flash_cs_n; wire spi_clk; wire usb_dp; wire usb_dn; wire usb_pu; wire uart_rx; wire uart_tx; // Setup recording // --------------- initial begin $dumpfile("top_tb.vcd"); $dumpvars(0,top_tb); # 2000000 $finish; end // DUT // --- top dut_I ( .spi_mosi(spi_mosi), .spi_miso(spi_miso), .spi_flash_cs_n(spi_flash_cs_n), .spi_clk(spi_clk), .usb_dp(usb_dp), .usb_dn(usb_dn), .usb_pu(usb_pu), .uart_rx(uart_rx), .uart_tx(uart_tx), .rgb(), .clk_in(1'b0) ); // Support // ------- pullup(usb_dp); pullup(usb_dn); pullup(uart_tx); pullup(uart_rx); spiflash flash_I ( .csb(spi_flash_cs_n), .clk(spi_clk), .io0(spi_mosi), .io1(spi_miso), .io2(), .io3() ); endmodule // top_tb